Tasarlanan optik toz sensörü ile güneş enerjisantrallerindeki enerji üretiminde tozlanma etkisinin incelenmesi
Investigation of the effect of dusting on energy production insolar power plants with the designed optical dust sensor
- Tez No: 846870
- Danışmanlar: DR. ÖĞR. ÜYESİ GÜLHAN USTABAŞ KAYA
- Tez Türü: Yüksek Lisans
- Konular: Elektrik ve Elektronik Mühendisliği, Electrical and Electronics Engineering
- Anahtar Kelimeler: Belirtilmemiş.
- Yıl: 2024
- Dil: Türkçe
- Üniversite: Zonguldak Bülent Ecevit Üniversitesi
- Enstitü: Fen Bilimleri Enstitüsü
- Ana Bilim Dalı: Elektrik-Elektronik Mühendisliği Ana Bilim Dalı
- Bilim Dalı: Belirtilmemiş.
- Sayfa Sayısı: Belirtilmemiş.
Özet
Güneş enerjisi santrallerindeki Fotovoltaik (PV) paneller, güneşten gelen fotonlar tarafından uyarılır. Uyarılma durumu ile fotoelektrik olay meydana gelir ve elektrik enerjisi üretimi meydana gelir. Güneş enerji santrallerinde enerji üretimi çevresel etkiler ile azalmaktadır. Bunların başında optimum sıcaklık değerinin üzerindeki sıcaklık ve panellerin üzerinde biriken toz miktarı gelmektedir. Optimum sıcaklığın üzerindeki bir sıcaklıkta panelin güç çıkışının düştüğü tersi durumda ise arttığı gözlemlenmektedir. Sıcaklık oluşumu panellerin üzerindeki tozlanmanın etkisinden de kaynaklanmaktadır. Bu nedenle yapılacak olan çalışmada tozlanmanın enerji üretimi üzerindeki etkisi optik yöntemle tasarlanacak bir sensör ile sıcaklığa bağlı olacak şekilde araştırılacaktır. Bu kapsamda yapılacak çalışmanın amaçlarını şu şekilde ifade edilmektedir: 1- Optik yöntem kullanılarak ölçüm teknolojilerinin araştırılması ve geliştirilmesi. 2- Tozlanmanın enerji üretimine etkisinin optik ölçüm yöntemine sahip tasarlanacak bir sensör ile tespit edilmesi. 3- Tozlanma oranının ışınım verilerine göre karşılaştırılması. 4- Tozlanma oranının panel altı sıcaklık verisi ile karşılaştırılması. 5- Toz oranının enerji üretimi üzerindeki etkisinin incelenmesi.
Özet (Çeviri)
Photovoltaic (PV) panels in solar power plants are excited by photons from the sun. With the excitation state, photoelectric effect occurs and electrical energy production occurs. Energy production in solar power plants decreases with environmental impacts. The most important of these are the temperature above the optimum temperature value and the amount of dust accumulated on the panels. It is observed that at a temperature above the optimum temperature, the power output of the panel decreases, and in the opposite case, it increases. Heat formation is also caused by the effect of dust on the panels. For this reason, in the upcoming study, the effect of dusting on energy production will be investigated in a temperature-dependent manner with a sensor designed using an optical method. The aims of the study to be carried out in this context are expressed as follows: 1- Research and development of measurement technologies using the optical method. 2- Detecting the effect of dusting on energy production with a sensor with an optical measurement method. 3- Comparison of dusting rate according to irradiance datas. 4- Comparison of dusting rate according to back of module temperature datas. 5- Examination of the effect of dusting rate on energy production.
Benzer Tezler
- Design, modelling and control of a nano quadrotor withmicrocontroller based vision system for object tracking
Nesne takibi için bir nano dört rotorlu helikopterin tasarımı, modellenmesi ve mikrodenetleyici tabanlı görüntü sistemi ile kontrolü
MUSTAFA ENES KIRMACI
Yüksek Lisans
İngilizce
2023
Makine Mühendisliğiİstanbul Teknik ÜniversitesiMakine Mühendisliği Ana Bilim Dalı
DR. ÖĞR. ÜYESİ HÜLYA YALÇIN
PROF. DR. ERDİNÇ ALTUĞ
- Design, analysis, simulation and optimization of a MEMS Lorentz force magnetic field sensor for biosensing of biowarfare agents
Biyolojik savaş ajanlarının tespit uygulamaları için Lorentz kuvveti temelli manyetik alan sensörünün tasarımı, analizi, simülasyon ve optimizasyonu
EMİNE RUMEYSA YILMAZ
Yüksek Lisans
İngilizce
2018
Elektrik ve Elektronik Mühendisliğiİstanbul Teknik ÜniversitesiNanobilim ve Nanomühendislik Ana Bilim Dalı
PROF. DR. LEVENT TRABZON
- Graphene oxide/calcium titanate composite preparation for humidity sensing by quartz crystal microbalance
Kuvars kristal mikrobalans ile nem tayinine yönelik grafen oksit/kalsiyum titanat kompozitlerin üretimi
ZEYNEP DEMİRTAŞ
Yüksek Lisans
İngilizce
2022
Biyomühendislikİstanbul Teknik ÜniversitesiNanobilim ve Nanomühendislik Ana Bilim Dalı
DOÇ. DR. BİRGÜL BENLİ
- Optik algılama yöntemiyle bilgisayar çıktısı programların okunması
Başlık çevirisi yok
SEMİH OMURTAK
Yüksek Lisans
Türkçe
1987
Elektrik ve Elektronik MühendisliğiAnadolu ÜniversitesiElektrik-Elektronik Mühendisliği Ana Bilim Dalı
DOÇ. DR. ATİLLA BARKANA
- Üç eksenli yer değiştirme ölçümü için fiber optik algılayıcı geliştirilmesi
Development of a fiber optic sensor for triaxial displacement measurement
YUNUS GÖRKEM
Yüksek Lisans
Türkçe
2022
Bilim ve TeknolojiKırşehir Ahi Evran Üniversitesiİleri Teknolojiler Ana Bilim Dalı
DR. ÖĞR. ÜYESİ ŞEKİP ESAT HAYBER