Geri Dön

Three-dimensional nonlinear dynamics and vibration reduction of gear pairs and planetary gears

Başlık çevirisi mevcut değil.

  1. Tez No: 403436
  2. Yazar: TUGAN ERİTENEL
  3. Danışmanlar: Prof. ROBERT G. PARKER
  4. Tez Türü: Doktora
  5. Konular: Makine Mühendisliği, Mechanical Engineering
  6. Anahtar Kelimeler: Belirtilmemiş.
  7. Yıl: 2011
  8. Dil: İngilizce
  9. Üniversite: The Ohıo State Unıversıty
  10. Enstitü: Yurtdışı Enstitü
  11. Ana Bilim Dalı: Belirtilmemiş.
  12. Bilim Dalı: Belirtilmemiş.
  13. Sayfa Sayısı: Belirtilmemiş.

Özet

Özet yok.

Özet (Çeviri)

This work aims to provide insight into the three-dimensional vibration of gears by investigating the mechanisms of excitation and nonlinearity coming from the gear tooth mesh. The focus is on gear pairs and planetary gears. The forces and moments generated at the gear tooth mesh cause three-dimensional relative displacements of contacting gear tooth, which disengage portions of gear tooth surface (partial contact loss) nominally designed to be in contact. While complete tooth disengagement (total contact loss) is the most commonly recognized nonlinearity in gears, partial contact loss is also a source of nonlinearity. A three-dimensional lumped-parameter gear mesh model produces the net force and moment at the gear mesh due to an arbitrary load distribution on the gear tooth surface using a translational and twist spring. Thus, the three-dimensional lumped-parameter model, named the equivalent stiffness model, concisely captures the nonlinear behavior. Both translational and twist stiffnesses depend strongly on spatial displacements at the gear mesh, and so are highly nonlinear and time-dependent. The twist moment periodically fluctuates over a mesh cycle, causing twist vibrations. With gear pairs, there is a twist vibration mode, where the twist stiffness is active, and a mesh deflection mode, where the translational stiffness is active. The dynamic response is nonlinear due to partial and total contact loss. The dynamic displacements distorts the instantaneous dynamic contact loads compared with the static design contact loads. To quantitatively assess nonlinear vibrations of gear pairs, a method is developed to give a closed-form analytical expression of the frequency-amplitude curve. Partial contact loss is captured with quadratic and cubic nonlinear terms. The vibration excitation comes from the time-dependent fluctuations due to periodic tooth engagement. The closed-form solution, found using the method of multiple scales, enables immediate calculation of nonlinear dynamic response, stability of the response, and the frequency range of total contact loss. With planetary gears, modes of vibration are crucial in understanding and reducing vibration. For equally-spaced planetary gears, all vibration modes belong to three types: 1) Rotational-axial modes (named for the displacements of the central members), 2) Translational-tilting modes (named for the displacements of the central members), and 3) Planet modes (only planets are active). This classification is mathematically derived. It depends only on planet spacing, and thus persists for axial asymmetry, e.g., use of helical gears, overhung shafts, different bearings at shaft ends. Planet spacing and gear tooth counts in planetary gears, when selected based on a set of rules, eliminate some force and moment fluctuation harmonics. It is shown that these fluctuations stem from the relative phase between planet gear meshes. The set of rules that eliminate force and moment fluctuations are derived. The derivation relies solely on the circumferential symmetry, so it is equally valid for static and dynamic conditions, elastic or rigid components, and for axially asymmetric systems.

Benzer Tezler

  1. 1981 Türkiye tarımsal yapısının önemli bileşenleri ve tarımsal bölgelerin elde edilmesi

    Principle components of Turkey's agricultural structure and to determine agricultural rigions in 1981

    İHSAN KARABULUT

    Yüksek Lisans

    Türkçe

    Türkçe

    1987

    İstatistikGazi Üniversitesi

    İstatistik Ana Bilim Dalı

    DR. MÜSLİM EKNİ

  2. Buğdayda farklı melezleme teknikleri kullanarak tohum tutma oranının saptanılması

    Başlık çevirisi yok

    İSMAİL TÜZÜN

    Yüksek Lisans

    Türkçe

    Türkçe

    1986

    ZiraatUludağ Üniversitesi

    Tarla Bitkileri Ana Bilim Dalı

    PROF. DR. HALİS RUHİ EKİNGEN

  3. Diyabetus mellitus'da gözlenen mikrovasküler komplikasyonların prostaglandinler ile olan ilişkisi

    The Relation of microvaskular complications observed in diabetes mellitus with prostoglandins

    CANAN NEBİGİL

    Doktora

    Türkçe

    Türkçe

    1985

    Eczacılık ve FarmakolojiCumhuriyet Üniversitesi

    Farmakoloji Ana Bilim Dalı

    YRD. DOÇ. DR. YUSUF SARIOĞLU

  4. Bazı sert çekirdekli meyve türlerinde döllenme biyolojisi üzerinde yöntem çalışmaları

    Başlık çevirisi yok

    ATBİMOĞLU ADALET

    Yüksek Lisans

    Türkçe

    Türkçe

    1985

    ZiraatEge Üniversitesi

    Bahçe Bitkileri Ana Bilim Dalı

    PROF. DR. RUHİNAZ GÜLCAN

  5. Kurutulmuş domates posasının yem değeri üzerine bir araştırma

    Başlık çevirisi yok

    A.İLTER POLAT

    Yüksek Lisans

    Türkçe

    Türkçe

    1987

    ZiraatUludağ Üniversitesi

    Zootekni Ana Bilim Dalı

    PROF. DR. M. RİFAT OKUYAN